COA Certified · Every Batch TestedSame-Day Shipping on Orders by 2PM ESTUSA Sourced · USA ShippedFree Shipping on Orders Over $3004.9/5 from 2,400+ Verified Researchers
COA Certified · Every Batch TestedSame-Day Shipping on Orders by 2PM ESTUSA Sourced · USA ShippedFree Shipping on Orders Over $3004.9/5 from 2,400+ Verified Researchers
Quality Peptide USAQuality Peptide USA
HomeResearchGHK-Cu + BPC-157
Lab Testing & Purity

GHK-Cu + BPC-157 Lab Testing & Purity Standards: HPLC, MS & Endotoxin

3 min readPublished 2025-07-16Quality Peptide USA Research

A two-peptide co-lyophilized blend pairing GHK-Cu (copper-binding tripeptide) with BPC-157 (stable pentadecapeptide). Used in dermal and soft-tissue research models.. This guide covers lab testing & purity for GHK-Cu + BPC-157 — written for laboratory researchers sourcing US-synthesized peptides from Quality Peptide USA.

Purity by Reverse-Phase HPLC

Every batch of GHK-Cu + BPC-157 is analyzed by reverse-phase HPLC using a C18 stationary phase and a water/acetonitrile gradient with 0.1% TFA. The release specification is ≥ 99% purity by area-under-curve at 220 nm. The chromatogram is included in the full certificate of analysis PDF available on the GHK-Cu + BPC-157 product page.

Identity by Mass Spectrometry

GHK-Cu + BPC-157 identity is confirmed by electrospray ionization (ESI) or MALDI-TOF mass spectrometry. The observed molecular ion is compared against the calculated mass (available on the certificate of analysis) and must match within 1 Da to pass release. Sequence-level confirmation is performed on representative lots through MS/MS fragmentation.

Endotoxin and Bioburden

Every batch is screened with the Limulus Amebocyte Lysate (LAL) assay. Release specification: < 0.10 EU/mg. Bioburden is verified by membrane filtration with target < 1 CFU per vial. These thresholds matter for cell-culture work where endotoxin contamination confounds inflammatory and proliferation readouts.

Water Content and Residual Solvents

Karl Fischer titration verifies water content below 5%, ensuring the lyophilized cake is fully dry. Residual organic solvent screening (gas chromatography) confirms acetonitrile and TFA residuals are within USP <467> Class 3 limits. This is one of the most overlooked QC steps when sourcing peptides from overseas suppliers — but it directly influences downstream cell viability.

Research Use Only

All content is for laboratory and in-vitro research contexts only. Not intended to diagnose, treat, or prevent any condition. Not for human or veterinary consumption.

GHK-Cu + BPC-157GHK-Cu + BPC-157 researchGHK-Cu + BPC-157 lab testing & purityGHK-Cu + BPC-157 for salebuy GHK-Cu + BPC-157GHK-Cu + BPC-157 US synthesizedGHK-Cu + BPC-157 American peptidesGHK-Cu + BPC-157 certificate of analysisresearch peptidesQuality Peptide USA